Publicidad
Idiomas disponibles
Idiomas disponibles
11
1- -1/4" FLAT HEAD SCREW (II)
NOTCHED
FILE
GLIDE (S)
STRAIGHT
FILE
FILE
CLIP (QQ)
GLIDE (R)
- Fasten two DRAWER SIDES (K3) to one of the DRAWER BOX FRONTS (J3) as shown in the top diagram. Use two
1- -1/4" FLAT HEAD SCREWS (II) through the holes in each DRAWER SIDE and into the holes in the edges of the DRAWER
BOX FRONT.
NOTE:
Be sure the grooves in each part line up with each other on the inside of the drawer.
- Slide a DRAWER BOTTOM (L2) into the grooves in the DRAWER SIDES and DRAWER BOX FRONT.
NOTE:
Be sure the finished surface of the DRAWER BOTTOM is facing up.
- Fasten another DRAWER BOX FRONT (J3) to the DRAWER SIDES (K3). Use four 1- -1/4" FLAT HEAD SCREWS (II) through
the holes in the DRAWER SIDES and into the holes in the edges of the DRAWER BOX FRONT.
NOTE:
Be sure the DRAWER BOTTOM fits into the groove in the DRAWER BOX FRONT.
- Press a NOTCHED FILE GLIDE (S) over both DRAWER SIDES (K3) on one of the drawers as shown in the bottom diagram.
Press a STRAIGHT FILE GLIDE (R) over both DRAWER BOX FRONTS (J3). The FILE GLIDES are necessary to hang files.
- The drawers are designed to hold letter, legal, or European-size files. If you wish to hang letter or European-size files, use the FILE
CLIPS (QQ) and the FILE RODS (PP).
the STRAIGHT FILE GLIDES (R) as needed.
NOTE:
The letter and European-size files will hang on the FILE RODS (PP) and the NOTCHED FILE GLIDES (S).
- If you wish to hang legal-size files, hang the files on the STRAIGHT FILE GLIDES (R).
- Repeat this step for the other drawer.
(16 used in this step)
FILE
ROD (PP)
FILE
CLIP (QQ)
Insert the FILE ROD (PP) into each FILE CLIP and slide the FILE CLIPS onto
Follow the diagram.
www.sauder.com/services
DRAWER
SIDE (K3)
DRAWER
BOX
FRONT (J3)
STRAIGHT
FILE
GLIDE (R)
NOTCHED
FILE
GLIDE (S)
DRAWER
BOX
FRONT (J3)
DRAWER
SIDE (K3)
Finished
surface
DRAWER
BOTTOM (L2)
101702
Publicidad
