Sauder Camden County 101702 Manual Del Usuario página 8

4
1- -1/4" FLAT HEAD SCREW (II)
(4 used in this step)
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the hole
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Fasten the TOP MOLDING (M) to the TOP (C) as shown. Use four 1- -1/4" FLAT HEAD SCREWS (II) through the
TOP MOLDING and into the pre- -drilled holes in the TOP.
NOTE: Be sure the finished surface of the TOP MOLDING is facing as shown.
- Fasten the LEFT END (B3) to the TOP (C) as shown. You will need to slide the END MOLDING (O2) on the LEFT
END down as you insert the TWIST-LOCK
FASTENERS in the LEFT END.
NOTE: You will need to slide the END MOLDING (O2) down a little to insert the TWIST-LOCK
FASTENERS into the TOP. The END MOLDING should be against the TOP MOLDING (M) after
the END is fastened.
- Fasten the BOTTOM (D) to the LEFT END (B3) as shown. Tighten the TWIST-LOCK
the BOTTOM.
NOTE: Be sure the surface with TWIST-LOCK
101702
END
MOLDING (O2)
LEFT
END (B3)
Surface with
TWIST-LOCK
FASTENERS
BOTTOM (D)
of the adjoining part while locking the FASTENER.
R
www.sauder.com/services
TOP
MOLDING (M)
Finished
surface
TOP (C)
R
R FASTENER (Refer to the enlarged diagram.)
FASTENERS into the holes in the TOP. Tighten the TWIST-LOCK
R
FASTENERS on the BOTTOM is facing as shown.
Groove
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
R
R
FASTENERS in
R