Publicidad
Idiomas disponibles
Idiomas disponibles
12
LOCKING
DRAWER
FRONT (H2)
Turn the KEY
counter--clockwise
to lock.
An enlarged portion of the LOCKING DRAWER FRONT (H2) is shown in this step.
- Fasten the LOCK (AA) to the LOCKING DRAWER FRONT (H2) in the exact order shown. It is important to make
sure the CAM points as shown. Meanwhile, the key must turn counter-clockwise 1/4 turn to lock properly. The CAM
should swing upward when locked.
NOTE:
If the key will not turn counter-clockwise, turn it clockwise and fasten the CAM as shown.
NOTE:
When the drawer is locked, the CAM should be positioned in the groove in the bottom surface
of the TOP (C).
101702
LOCK
The prongs must press into the
LOCKING DRAWER FRONT
as you tighten the NUT with an
adjustable wrench.
www.sauder.com/services
CAM
NUT
WASHER
This end of the CAM
must be farther away
from the LOCKING
DRAWER FRONT
than the other end of
the CAM.
SCREW
Publicidad
