Publicidad
Idiomas disponibles
Idiomas disponibles
13
EXTENSION
SLIDE (SS)
3
4
PULL (BB)
with PULL
MOUNTS (CC)
The LOCK
must be here.
1/2" FLAT HEAD SCREW (LL)
(4 used for the DRAWER ACTUATORS)
- Insert a PULL MOUNT (CC) into one of the holes in the LOCKING DRAWER FRONT (H2). Insert one end of a PULL (BB)
into the hole in this PULL MOUNT. Insert the other end of the PULL into another PULL MOUNT and insert it into the other hole in
the LOCKING DRAWER FRONT.
- Now, fasten the PULL MOUNTS to the DRAWER BOX FRONT (J3). Use four 1- -1/4" MACHINE SCREWS (JJ) through the
holes in the DRAWER BOX FRONT and into the PULL MOUNTS on the LOCKING DRAWER FRONT (H2).
NOTE:
Be sure the LOCK in the LOCKING DRAWER FRONT is in the location shown. The DRAWER FRONT
should overhang the top of the drawer more. Do not overtighten the SCREWS. Follow the diagram
closely.
- Fasten an EXTENSION SLIDE (SS) to each DRAWER SIDE (K3) as shown. Use a 7/16" LARGE HEAD SCREW (NN) through
holes #1 and #3 from the open end in each EXTENSION SLIDE and into the exact pre- -drilled holes shown in the DRAWER SIDE.
NOTE:
Be sure the open ends of the EXTENSION SLIDES are located toward the back of the drawer.
- Fasten a DRAWER ACTUATOR (X) to the right DRAWER SIDE (K3) as shown. Use two 1/2" FLAT HEAD SCREWS (LL)
through the indicated holes and into the pre- -drilled holes in the DRAWER SIDE.
NOTE:
Be sure to position the DRAWER ACTUATOR as shown. Be sure to use the two indicated holes. Follow
the enlarged diagram closely.
Repeat this step for the other drawer.
-
Open
end
1
2
DRAWER
SIDE (K3)
DRAWER
BOX
FRONT (J3)
PULL (BB)
with PULL
MOUNTS (CC)
LOCKING
DRAWER
FRONT (H2)
www.sauder.com/services
1- -1/4" MACHINE SCREW (JJ)
(8 used for the PULL MOUNTS)
DRAWER
SIDE (K3)
4
Use these
two holes.
DRAWER
ACTUATOR (X)
7/16" LARGE HEAD SCREW (NN)
(8 used for the SLIDES)
Open
end
1
2
EXTENSION
SLIDE (SS)
3
101702
Publicidad
