Sauder Camden County 101702 Manual Del Usuario página 6

2
These edges
should be even.
Slide the END
MOLDING (O2) onto
the notched edge.
- Slide a patented* END MOLDING (O2) onto the notched edge of each END. Carefully slide both MOLDINGS
until the MOLDINGS are even with the top edge of each END.
NOTE: The MOLDINGS should overhang the surface with holes. If the MOLDING overhangs the
wrong surface, remove it and slide it on again. Slide the MOLDING off the notched edge in
the same direction that it was slid on.
* U.S. Pat. No. 5,499,886
101702
Slide the END
MOLDING (O2) onto
the notched edge.
END
MOLDING (O2)
LEFT
END (B3)
END
MOLDING (O2)
www.sauder.com/services
RIGHT
END (A3)