Stanley CROSS 90 Manual Del Usuario página 12

Applications
Plumb Transfer
• Using the vertical laser beam, establish a vertical
reference plane.
• Position thve desired object(s) until they are aligned
with the vertical reference plane to ensure object(s)
are plumb.
Level Transfer
• Using the horizontal laser beam, establish a horizontal
reference plane.
• Position the desired object(s) until they are aligned
with the horizontal reference plane to ensure object(s)
are level.
Square
• Using the vertical and horizontal laser beams, establish
a poing where the two beams cross.
• Position the desired object(s) until they are aligned with
both the vertical and horizontal laser beams to ensure
objects(s) are square.
Manual Mode (See figures
• Disables self-leveling function and allows laser unit to
project a rigid laser beam in any orientation.
Batteries and Power
Battery Installation / Removal (See figure
Laser Tool
• Turn laser tool to battery door and open.
• Install / Remove batteries. Orient batteries correctly
when placing into battery compartment.
• Close battery door. Be sure that the door has been
closed securely.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
12
)
C
)
B
STHT77341
Set Up
Laser Tool
• Place laser tool on a flat, stable surface.
• If using the auto leveling feature move the pendulum /
transport lock to the unlocked position. The laser tool
must then be positioned in its upright position on a
surface that is within the specified compensation range.
• The laser tool can be placed in any orientation and be
functional only when the pendulum / transport lock is in
the locked position.
Mounting on Accessories
• Position accessory in a place where it will not be easily
disturbed and near the central location of the area to
be measured.
• Set up the accessory as required. Adjust positioning to
be sure accessory base is near horizontal (within laser
tools compensation range).
• Mount the laser tool to the accessory using the
appropriate fastening method to be used with such
accessory / laser tool combination.
CAUTION:
• Do not leave the laser tool unattended on an
accessory without fully tightening the fastening
screw. Failing to do so may lead to the laser tool
falling and sustaining possible damage.
NOTE:
• It is best practice to always support laser tool with
one hand when placing or removing laser tool from an
accessory.
• If positioning over a target, partially tighten the fastener,
align laser tool, and then fully tighten.