Operating Elements; Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel SR Instructivo De Servicio

5 Operating elements

5 Operating elements
5.1 Trigger with two-cycle function

6 Putting out of operation

7 Maintenance and cleaning

EN - 8
NOTE
• As the TIG welding torches are integrated into a welding system, the
operating instructions of the welding components, such as power supply,
must be observed during operation.
Using a standard welding torch, the two-cycle mode of the trigger can be
activated. Further operating modes and handle modules depend on the
corresponding welding power supply and must be ordered separately.
1 Press the trigger on the handle and keep it pressed = welding is started.
2 Release the trigger = welding is stopped.
1 Switch off power supply.
2 Close the valve of the shielding gas cylinder.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and
repair work, the following instructions must be adhered to:
• Switch off the power supply and disconnect the gas supply.
• Pull the mains plug.
Sharpening the tungsten electrode
Sharpening the tungsten electrode depends on wear and must therefore be
carried out when required.
Fig. 2 Sharpening the tungsten electrode
®
SR/ABITIG /ABITIG
®
GRIP