Boosting The Bass; Adjusting Source Levels - Pioneer SUPER TUNER III D DEH-3850MP Operación Manual

Section
07
Audio Adjustments
# When the rear output setting is R-SP :S/W,
you cannnot select F.I.E. function.
2 Press a to turn F.I.E. on.
# To turn F.I.E. off, press b.
3 Press c or d to select a desired fre-
quency.
Each press of c or d selects frequency in the
following order:
100160250 (Hz)
Notes
! After turning the F.I.E. function on, use the bal-
ance adjustment (refer to page 22) and adjust
front and rear speaker volume levels until they
are balanced.
! Turn the F.I.E. function off when using a 2-
speaker system.

Boosting the bass

Bass boost function boosts the bass level of
sound lower than 100 Hz. The more the bass
level is increased, the more the bass sound is
emphasized and the entire sound becomes
powerful. When using this function with the
subwoofer, the sound under the cut-off fre-
quency is boosted.
1 Press AUDIO to select BASS.
Press AUDIO until BASS appears in the dis-
play.
# You can also select the bass boost setting by
pressing and holding SW.
2 Press a or b to select a desired level.
0  6 is displayed as the level is increased or
decreased.
26
En
All manuals and user guides at all-guides.com

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Press AUDIO to select SLA.
Press AUDIO until SLA appears in the display.
3 Press a or b to adjust the source vo-
lume.
Each press of a or b increases or decreases
the source volume.
SLA : +4  SLA : 4 is displayed as the source
volume is increased or decreased.
Note
The AM tuner volume level can also be adjusted
with source level adjustments.