Stryker M-1 Manual Del Usuario página 11

I I n n s s t t a a l l l l a a t t i i o o n n
I I n n s s t t a a l l l l i i n n g g t t h h e e c c o o t t f f a a s s t t e e n n e e r r
The Stryker M M - - 1 1 Cot Fastener systems are compatible only with cots that conform to the installation specifications.
W W A A R R N N I I N N G G
• Install the cot fastener by qualified personnel only. Improper installation could result in injury to the patient or operator.
• Always make sure that all cots meet the installation specifications for the Stryker cot fastener system.
N N o o t t e e - - Federal ambulance specifications regarding aisle width and attendant seating may affect positioning of the mounting
brackets. If specifications do not apply, the installer should make sure that there is adequate clearance for proper patient
access, traction splint projection, rear door closure, etc.
To install the cot fastener in a vehicle:
1. Determine the desired position of the cot inside the vehicle allowing for proper clearance around the cot.
N N o o t t e e - - If DIN hardware is already in place, use the dimensions in Figure 3, Figure 4, Figure 5, and Figure 6 as a
reference to locate the fastener assembly.
6373-009-005 Rev F.0 7 EN