Troubleshooting - Gude GFO 1801 Traducción Del Manual De Instrucciones Original

IN CASE OF EMERGENCY
Initiate the first aid measures necessary for the injury
and request qualified medical assistance as soon as
possible. Safeguard the injured person from further
injury and keep them calm. A first aid kit according
to DIN 13164 should always be available at the work-
place in case of an accident. Any material removed
from the first aid kit must be replaced immediately.
If you request help, please provide the following
information:
1. Location of the accident
2. Type of accident
3. Number of injured persons
4. Type of injuries
WARRANTY
The warranty period is 12 months for commercial use,
24 months for consumers and begins with the date of
purchase of the machine.
The warranty covers exclusively defects attributable
to material or manufacturing defects. In the event
of the assertion of a defect within the meaning of
the warranty, the original proof of purchase must be
enclosed with the date of sale.
The warranty does not cover improper use, e.g., over-
loading the machine, use of excessive force, damage
caused by external influences or foreign objects.

TROUBLESHOOTING

Problem
The motor doesn't run.
The motor switches off during
operation.
Burn marks on the workpiece.
Non-observance of the operating and assembly inst-
ructions and normal wear and tear are also excluded
from the warranty.
SERVICE
Do you have a technical question? A complaint? Do
you need spare parts or operating instructions? On
the homepage of Güde GmbH & Co. KG (www.guede.
com) in the Service section, we will help you quickly
and without bureaucracy. Please help us to help you.
In order to be able to identify your machine in the
event of a complaint, we need the serial number as
well as the item number and year of manufacture. All
this data can be found on the rating plate. To always
have these data at hand, please enter them below.
Serial number:
Item number:
Year of manufacture:
Cause
There's no power coming to the
machine. Check power supply and
supply cable, consult a qualified
electrician.
The thermal sensor has interrup-
ted the power supply.
The motor thermal sensor is
defective.
The motor protection switches off
due to overload.
Sharpen or replace the saw blade.
The saw blade is not sharp
enough.
The teeth of the saw blade do not
have the correct set.
Saw blade is blunt.
Solution
Wait 5-10 minutes and then switch
on again.
Only replace it by a qualified
electrician.
Wait until the motor has cooled
down and restart the machine after
5-10 minutes.
Connect the extension cable accor-
dingly 1.5 mm .
2
Sharpen the saw blade.
Have a specialist set the blade.
Sharpen or replace the saw blade.
35