Ingersoll Rand TS1A-13A Manual De Manejo Y Mantenimiento página 8

Electrical
The dryer has high and dangerous voltage in the motor starter and
control box. All installations must be in accordance with recognized
electrical codes. Before working on the electrical system, be sure to
remove voltage from the system by using a manual disconnect switch.
A circuit breaker or fuse safety switch must be provided in the electrical
supply line leading to the dryer.
Those responsible for installation of this equipment must provide
suitable grounds, maintenance clearance and lightning arrestors for all
electrical components in accordance with National and Local code
requirements.
Keep all parts of the body and any hand–held tools or other conductive
objects, away from exposed live parts of the dryer electrical system.
Maintain dry footing, stand on insulating surfaces and do not contact
any other portion of the dryer when making adjustments or repairs to
exposed live parts of the dryer electrical system.
Close all access doors when the dryer is left unattended.
Do not use extinguishers intended for Class A or Class B fires on
electrical fires. Use only extinguishers suitable for class BC or class
ABC fires.
Attempt repairs only in clean, dry, well lighted and ventilated areas.
Connect the dryer only to electrical systems that are compatible with
its electrical characteristics and that are within it's rated capacity.
Condensate disposal
Condensate cannot be discharged into fresh/surface water drains. In
some regions compressor condensate containing ULTRA COOLANT
can be fed directly into a drainage system that has downstream
sewage treatment.
As waste water regulations vary by country and region it is the
responsibility of the user to establish the limitations and regulations in
their particular area. Ingersoll Rand and its associated distributors are
happy to advise and assist in these matters.
Refrigerant Oil
Steps to be taken in the case of spillage: Soak up with a suitable
absorbent material, then sweep into a plastic bag for disposal.
6
All manuals and user guides at all-guides.com
5.0 SAFETY
TS1A–13A
http://air.irco.com
Burn in an approved incinerator, or according to local area or country
regulations.
For further information, consult Material Safety Data Sheets
WARNING
There is a high temperature shutdown feature built into each
dryer. Refer to maintenance section for service.
Failure to adhere to these recommendations can result in
mechanical failure, property damage and serious injury or death.
S All air and water inlet, and air and water discharge pipework to
and from the inlet and discharge port connections must take into
account vibration, pulsations, temperature, maximum pressure
applied, corrosion and chemical resistance. In addition, it should
be noted that lubricated compressors will discharge some oil into
the air stream; therefore, compatibility between discharge piping,
system accessories and software must be assured.
S For the foregoing reasons, the use of plastic piping, soldered
copper fittings and rubber hose as air piping is not recommended.
In addition, flexible joints and/or flex lines can only be considered
for such purposes if their specifications fit the operating
parameters of the system.
S It is the responsibility of the installer and owner to provide the
appropriate service pipework to and from the machine.
WARNING
"Ingersoll Rand air dryers are not designed, intended, or
approved for breathing air applications. Ingersoll Rand does not
approve specialized equipment for breathing air application and
assumes no responsibility or liability for dryers used for
breathing air services."
WARNING
The specification of this machine is such that the machine is not
suitable for use in flammable gas risk areas.
WARNING
Vent compressed air system before opening.