Trou Bles H Oot| Ng - Troy-Bilt 030247 Manual Del Operario

Troubleshooting
7
TROU BLES H OOT| NG
Problem
No AC output is available, but
generator is running.
Generator runs good at no=load
but "bogs" down" when loads are
connected.
Generator will not start; or starts
and runs rough.
Generator shuts down during
operation.
Generator lacks power.
Cause
I. One of the circuit breakers is
open.
2. Fault in generator.
3. Poor connection or defective cord
se[.
4. Connected device is bad.
I. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
I. Failed battery.
2. Low oil level.
I. Out of gasoline.
2. Low oil level.
Load is too high.
Correction
I. Reset circuit breaker.
2. ContactAuthorized service facility.
3. Check and repain
4. Connect another device that is in
good condition.
I. Disconnect shorted electrical load.
2. See "Don't Overload Generator".
3. ContactAuthorized service facility.
I. Replace battery.
2. Fill crankcase to proper level or
place generator on level surface.
I. Fill fuel tank.
2. Fill crankcase to proper level or
place generator on level surface.
See "Don't Overload Generator".
O