Add Engine Oil - Troy-Bilt 030247 Manual Del Operario

Section 3: Assembly
BEFORE STARTING THE
ENGINE
Add Engine Oil
• Place generator on a level surface.
I CAUTION
1
• Refer to engine operator's manualfor oil fill information.
" Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.
NOTE: The generator assembly rotates on a prelubrJcated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Add Fuel
NOTE: This gasoline engine is certified to opera[e on
gasoline. Exhaust Emission Control System: EPi (Engine
Modifications).
|WARNING
WHEN ADDING FUEL
Turn
generator
OFF and let
it cool
at least 2 minutes before
removing fuel cap. Loosen cap slowly to relieve pressure JR
tank.
Fill fuel tank outdoors.
DO NOT overfill tank.Allow spacefor fuel expansion.
If fuel spills,wait until it evaporates before starting engine.
Keep fuel awayfrom sparks, open flames, pilot lights, heat, and
other ignition sources.
DO NOT light a cigarette or smoke.
Use clean, fresh, regular UNLEADED gasoline with a
minimum of 85 octane. DO NOT use fuel which
contains Methanol. DO NOT mix oil with fuel.
2. Clean area around fuel fill cap, remove cap.
3. Slowly add regular unleaded fuel 1:o fuel tanl<. Be careful
not to overfill.Allow about 1.5" of tank space for fuel
expansion (Figure 3).
• - - D, e
4. Install fuel cap and let any spilled fuel evaporate before
starting engine.
O