Troy-Bilt 030247 Manual Del Operario página 6

Ocultar thumbs Ver también para 030247:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly
ASSEMBLY
Your generator
requires
some
assembly
and is ready
for
use after
i[ has been
properly
serviced
wi[h
the
recommended
oil and fuel.
If you have any problems with the assembly of your
generaton please call the generator heIpline at
[=888=6 [ I =6708. If calling for assis[ance, please have [he
model, revision, and serial number from the dam tag available.
See "KnowYour
Generator"
for data tag location.
Unpack
the Generator
I.
Se[ [he car[on on a rigid flat surface.
2.
Open carton completely
by cutting each corner from
top [o bo[tom.
3.
Remove every[hing from car[on excep[ generator.
4.
Leave generator
on carton to install wheel kit.
Carton
Contents
Check all con[ents agains[ [hose listed below:
• Main unit
• Engine oil
• Operator's
manual
• Engine operator's
manual
• Bat[ery float charger
• Wheel I<i[
If any parts are missing or damaged, call [he genera[or
heipline a[ 1=888=611=6708.
install Wheel
Kit
The wheel I<i[ is designed [o gready improve [he portabili[y
of your genera[or.
NOTE:
Wheel I<i[ is no[ in[ended for over-[he-road
use.
You wi[[ need [he following
[ools [o install [his wheel ki[:
• I/2" or 13mm socke[wrench
• 1/2" or 13mm open end wrench
• Pliers
• Safely glasses
Refer to Figure
[ and install the wheel
kit as follows:
I.
Tip generator
so that engine end is up.
2.
Slide axle [hrough
bo[h mounting
bracke[s.
3.
Slide a wheel over [he axle.
NOTE:
Be sure [o install both wheels wi[h [he air
pressure valve on [he ou[board
side.
Wheel
Axle
Fia[ Washer
Suppor[
Leg --
20 mm Cap Screw
E-Ring
O

Publicidad

Tabla de contenido
loading

Tabla de contenido