Next Level Racing Elite Serie Manual De Instrucciones página 10

support@nextlevelracing.com
11b 00
Slide angle bracket over the T-nuts installed on step 11a
REPEAT ON
OTHER SIDE
11c 00
Bolt Angle bracket into T-Nuts previously installed in step 11a
PARTS:
1 X ANGLE BRACKET
PARTS: PARTS:
8 X M8 16MM BOLT 4 x M8 16mm bolts
4 x M8 Washers
8 X M8 WASHERS
TIPS:
TIPS:
Text for hints and tips for building
Do not over tighten as there will
this step
be a need to adjust for screen
alignment
18
(A)
(B)
REPEAT ON
OTHER SIDE
00 12
Bolt through angle bracket into pre-drilled hole in the outer arm Main text descrition for step here
13a 00
Install 1 x T-Nut into the top and bottom channel of the puter arm as shown (Red dot indicates T-nut
Main text descrition for step here
location)
Video Instruction: bit.ly/nlrbuild
PARTS: PARTS:
Parts List here
2 X M8 100MM BOLTS
2 X M8 WASHER
TIPS:
2 X M8 FLANGE NUT
Text for hints and tips for building
this step
TIPS:
Outer arm shown in (A) has a pre-
drilled hole all the way through. Line
this up with the bracket
PARTS: PARTS:
Parts List here 4 X T-NUT
TIPS:
Text for hints and tips for building
this step
REPEAT ON
OTHER SIDE
19