Next Level Racing Elite Serie Manual De Instrucciones página 13

support@nextlevelracing.com
19
Bolt the overhead angle plates into T-Nuts previously installed in step 18
(1)
20a
(1) Install 1 x T-Nut into the top and side channel of the overhead cross member as shown. (2) Install 3
x T-nut into the outside channel of each overhead angle member as shown
PARTS:
4 X M8 16MM BOLT
4 X M8 WASHER
TIPS:
Do not fully tighten as height will be
adjusted later
PARTS:
8 X T-NUT
(2)
24
20b
Bolt the square plates to the overhead angle members using T-Nuts previously installed
in step 20a (2)
20c
Bolt through square plates into the overhead crossmember from 20a (1) Then install 40x40 end cap
Video Instruction: bit.ly/nlrbuild
PARTS:
4 X M8 16MM BOLT
4 X M8 WASHER
2 X SQUARE PLATE
PARTS:
4 X M8 16MM BOLT
4 X M8 WASHER
TIPS:
Recommended to install 40x40 end
caps on this step
25