Next Level Racing Elite Serie Manual De Instrucciones página 11

support@nextlevelracing.com
(A)
BACK VIEW
(B)
REPEAT ON
OTHER SIDE
13b 00
(A) Adjust the outer arms to your desired angle and bolt through the angle bracket using T-Nuts previ-
Main text descrition for step here
ously installed in step 13a (B) Slide 1 x T-nut into the top channel and 1 x T-nut into bottom side channel
REPEAT ON
OTHER SIDE
14
Install your screens using T-nuts previously installed in step 13b. Please refer to step 07a and 07b for
Vesa mount assembly steps. Install end caps to the outer arms once alignment is finished
PARTS: PARTS:
Parts List here
4 X M8 16MM BOLT
4 X M8 WASHER
TIPS:
4 X T-NUT
Text for hints and tips for building
TIPS:
this step
Use line holes in swing bracket to
align to desired location
PARTS: PARTS:
4 X M8 16MM BOLT Parts List here
4 X M8 WASHER
2 X END CAP 80X40 TIPS:
Text for hints and tips for building
this step TIPS:
Adjust for your desired tilt angle
20
00 15
Adjust your screens to desired position Main text descrition for step here
00 16
The triple monitor stand is now complete Main text descrition for step here
Video Instruction: bit.ly/nlrbuild
PARTS: PARTS:
Parts List here
NIL
TIPS:
Text for hints and tips for building
this step
PARTS: PARTS:
NIL Parts List here
TIPS:
TIPS:
Text for hints and tips for building
this step
Install cable management clips
where desired
21