Next Level Racing Elite Serie Manual De Instrucciones página 3

support@nextlevelracing.com
PRE-RACE
CHECKS
WARNING & ASSEMBLY TIPS
• Please do not use power tools for assembly as over tightening can damage your frame
• Please ensure T-Nuts are correctly placed within the extrusion to prevent damaging parts
• Lay out and build the monitor stand on a soft and protected level surface
• Do not force parts together
• Avoid cross threading threaded items
• If in doubt consult the installation video (see QR code below or contact us at support@nextlevelracing.com)
• Do not hang additional loads on the monitor stand
• T-nuts cannot be installed mid channel. Must be installed from the ends of the profile
• Beware of sharp edges on extrusion pieces
• Plan the placement of cable management clips at the beginning of your build
If you require any support with
your product please contact our friendly team at:
support@nextlevelracing.com
WARNING
CHOKING HAZARD - Small parts not for children under 3 years
or any individuals who have a tendency to place inedible objects
in their mouths.
ASSEMBLY
VIDEO
bit.ly/nlrbuild
4
IN THE
BOX
SINGLE MONITOR STAND
1 x 80x40 Upper cross member
3 x left 40x100 end cap 3 x right 40x100 end cap
R
L
2 x Vertical members 80x40 1 x vesa mount
6 x M8 12mm wingbolt 24 x M8 washers
Video Instruction: bit.ly/nlrbuild
L
R
Allen keys
2 x Base members 100x40
18 x T-nut
4 x T-nut Regular
4 x cable clip
1 x Level 1 x wrench
4 x M6 washer
4 x M5 washer
4 x M4 washer
5 x 40x80 end cap
2 x corner plate 4 x 85mm bolt 4 x M8 40mm bolt
4 x M6 15mm bolt
4 x M5 15mm bolt
4 x feet 12 x M8 16mm bolt
4 x M4 15mm bolt
5