Next Level Racing Elite Serie Manual De Instrucciones página 7

support@nextlevelracing.com
VISA MOUNT
T-NUTS
MAIN CROSS MEMBER REAR SIDE VIEW
overhead monitor only overhead monitor only
2 x T-nut for 2 x T-nut for 1 x T-Nut to the 2 x T-nut for
the left vertical the overhead vertical middle for the the overhead vertical
member member vesa mount member
04a
Install 10 x T-Nuts into the cross member as shown
1 2
3 4
Align set
tab
04b
Install T-nut into frame then screw feet into T-nut
PARTS:
10 X T-NUT
TIPS:
Red dots indicate general T-nut
positioning
Countersunk holes in cross member
to be on the front of the cross
member, T-nuts installed on the
rear side
2 x T-nut for
the right vertical
member
PARTS:
4 X T-NUT REGULAR
4 X FEET
TIPS:
Use alignment tab of foot cap
Adjust to desired height and/or level
then tighten with Allen key
Assemble on side for easy
installation
12
05 00
Bolt the upper cross member to the vertical members using T-Nuts previously installed in step 03a Main text descrition for step here
REPEAT ON
OTHER SIDE
06 00
Bolt corner plate to T-Nuts previously installed in step 4a and step 3b. Repeat on the other side Main text descrition for step here
Video Instruction: bit.ly/nlrbuild
PARTS: PARTS:
Parts List here
4 X M8 40MM BOLT
4 X M8 WASHER
TIPS:
Text for hints and tips for building
TIPS:
this step
You may find it easier to add the
washers into the channel prior to
the bolts
Get a friend to help you hold parts
in position
This step sets your screen height
PARTS: PARTS:
8 X M8 16MM BOLT Parts List here
8 X M8 WASHER
2 X CORNER PLATE TIPS:
Text for hints and tips for building
this step
13