Technical Data - Hilti DX 6 Manual De Instrucciones

In addition, be sure to study all the notes on operation in the app. This will give you a better overview
of how the connection is made and how the functions are used.
3.6 Information about the app
To find out more about the app, to download it and start it, scan the QR code in the case.
3.7 Requirements to be met by cartridges
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EU and EFTA countries that the cartridges must be CE-compliant and must bear
the CE mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridge must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
WARNING! Use of cartridges that do not meet the minimum safety requirements can lead to a build-
up of unburned powder. A sudden explosion and severe injuries to the operator and bystanders can
result. A build-up of unburned powder can be prevented only by professional cleaning by Hilti Service.
Cartridges
Ordering designation
DX 6 cartridge
DX 6 cartridge
3.8 Minimum distances and edge distances
WARNING! You must always observe certain minimum distances and spacing when driving
fasteners. They can differ, depending on the product.
For detailed information, request a copy of the Direct Fastening Technology Manual from the local
Hilti Store Store.
Fastening to concrete or steel
Description
minimum distance from the edge of the base material to the
fastener
minimum center-to-center distance between fasteners
minimum base-material thickness
3.9 Information about the field of applications
See the Hilti product page for more information about the areas of application.
4

Technical data

WARNING! Always remove the cartridge strip whenever work is interrupted. In this way you avoid
deformation of the plastic strip and the risk of injury due to self-firing in an overheated fastening tool.
When you work at the maximum fastener driving rate, allow the fastening tool to cool down after one hour of
constant work.
*2232121*
2232121
Color Power level
titanium-gray strong
black extra-strong
Concrete Steel
≥ 70 mm ≥ 15 mm
≥ 80 mm ≥ 20 mm
≥ 100 mm Follow the instruc-
tions in the operat-
ing instructions of
the fastener!
English 25