u Hold the monitor with the anti-glare visor in the monitor holder and
manually turn in the M 5 x 18 mm knurled screws.
u Align the monitor and tighten the knurled screws.
For parts required to fasten the monitor, see . F 13 to F 15.
Attention! If the vehicle height or length registered in the vehicle
documents is altered by the installation of the camera, it is
necessary to have the vehicle reinspected by the responsible
authorities (TÜV, DEKRA etc.). Have your vehicle documents
amended accordingly.
Warning! Select the position of the outside camera and fasten it
securely to exclude the risk of injury to persons standing near the
vehicle (by branches scraping over the roof).
As the outside camera has to be positioned at least 2 m high to
ensure a suitable viewing angle, make sure that the workplace is
suitably secure.
General fitting instructions!
Before fitting the outside camera, observe the following points:
– The outside camera has to be positioned at least 2 m high to ensure a
suitable viewing angle.
– Ensure that the installation point for the outside camera is suitably
secure (e.g. branches scraping over the vehicle roof could catch on
the camera).
– Fit the camera in a horizontal and central position at the rear end of
the vehicle (see . G 5).
Attention! Ensure that you use the supplied insulation base and
the insulation sleeves (see . G 2 and G 3). They prevent fault
current from occurring as a result of poor earth connection in the
vehicle. Fault currents could lead to streaks in the image or a hum
in the loudspeaker or even damage to the system.
Please route the camera cable so that the plug connection between the
camera and connection cable is easily accessible in case it becomes
necessary to dismantle the camera. This considerably facilitates
dismantling.
All manuals and user guides at all-guides.com
Installing the monitor
Fitting the outside camera
45