Fitting The Parking Aid; Connecting The Parking Aid - Waeco MagicWatch MWE910 Instrucciones De Montaje Y De Uso

All manuals and user guides at all-guides.com

Fitting the parking aid

5 Fitting the parking aid
See fig. 8 to fig. e
Supplementary to fig. 9
➤ Clean the adhesive surface on the inner side of the bumper with a primer.
Supplementary to fig. 0
Caution – risk of malfunction
a
Align and attach the sensor holders correctly. Otherwise the correct
function of the parking aid cannot be ensured.
The sensor holders must be attached with the retaining tabs point-
ing up and down.
6

Connecting the parking aid

See fig. f
Note
I
On some vehicles, the reversing light only works when the ignition
is switched on. In this case, you must switch on the ignition in order
to identify the positive and earth wires.
Note
I
You can set a switch-off time for the front sensors if you are unable
to connect the control electronics of the front sensors to the speed-
ometer (e. g. no speedometer signal or signal via CAN bus).
The front sensors are activated by switching on the ignition and de-
activated after the set time (parameter 12).
A MWS-910 switch (accessory) can also be used to activate the
front sensors.
18
MagicWatch MWE910