Filter Cartridges; Technical Data And Specifications - SATA 400 Instrucciones De Servicio

Operating instructions SATA filter 400

2.4. Filter cartridges

Type:
Sintered filter cartridge
5 μm, surface area 100 cm²,
solvent regenerable
Replacement interval every
six months
Art. No. 22160
In case of extreme contamination, filters should be checked and, if necessary, replaced more frequently. The
sintered bronze filter (8) and the filter housing tube (7,11) must be cleaned every six months at the latest, if
necessary, replace sintered bronze filter cartridge. Saturated filter cartridges bear the danger of functional
defaults during painting resp. affecting the painter's health while using supplied-air respirator systems.

3. Technical data and specifications

- Air inlet G 1/2 inside thread
- Maximum inlet operating pressure 15 bar/225 psi; 1,5 MPa
for SATA filter 434; SATA filter 464 = 10 bar/150 psi; 1,0 MPa
- Maximum outlet operating pressure 10 bar; 1,0 MPa
- Air flow rated at 3600 NI/min (129,6 cfm) at 6 bar/90 psi
- Max: ambient temperature 120° C (248 F) with activated charcoal unit max:
ambient temperature 60 ° C (140 F)
Weight:
SATA filter 414
SATA filter 414L
SATA filter 424
SATA filter 424L
SATA filter 434
SATA filter 434L
SATA filter 464
SATA filter 464
(Add-on module)
Combination filter:
SATA filter 444
SATA filter 444L
SATA filter 474
SATA filter 484
SATA filter 494
Fine filter cartridge, Polypropy-
lene Micro Fibre layer Surface area
300 cm² Filtering capacity 0,01 μm
99,998 % separation,
non-regenerable
Replacement interval every
six months, at the latest when
the maximum pressure diffe-
rence between inlet and outlet
pressure is 1 bar/14.5 psi
Art. No. 81810
= 2,2 kg
= 1,5 kg
= 2,7 kg
= 2,0 kg
= 2,3 kg
= 1,6 kg
= 2,3 kg
= 1,5 kg
= 4,3 kg
= 3,5 kg
= 3,9 kg
= 5,9 kg
= 6,6 kg
Activated charcoal cartridge
non-regenerable
Replacement interval every
three months
Art. No. 85373
VIII.3