Bypass Feed (Including Special Paper) - Sharp AR-153E N Manual De Instrucciones

BYPASS FEED (including special paper)

The multi-bypass tray (AR-153EN) or the single bypass (AR-122EN/AR-152EN) can
be used to feed standard paper, transparency film, labels, envelopes, and other
special purpose paper. Paper measuring from A6 to A4 and in the weight range of 52
to 128g/m
the maximum size.)
The multi-bypass tray (AR-153EN)
1
Open the multi-bypass tray and extend the tray.
2
Set the paper guides to the paper width. Insert the paper (print
face down) all the way into the multi-bypass tray.
10
Downloaded from:
2
can be used in this tray. (For paper weighing from 104 to 128g/m
• The multi-bypass tray (AR-153EN) can hold maximum of 50 sheets of
paper. (Capacity will vary depending on the type of paper loaded.) The
single bypass (AR-122EN/AR-152EN) can hold one sheet of paper.
• The original image must be smaller than the paper or media for
copying. If the original image is bigger than the paper or media, this
may cause smudges on the edges of the copies.
To close the multi-
bypass tray, perform
step 1 and then step
Nota
2 in the illustration
and push the round
projections at the
right of the tray until
they click.
http://www.usersmanualguide.com/
2
, A4 is
Cara de impresión