Sharp AR-153E N Manual De Instrucciones página 43

5
6
Downloaded from:
• If you are using the parallel interface connection, do not select the
Button Manager checkbox because this feature is not supported with
the parallel interface.
• If the following screen appears, click the "OK" button. Review the
contents in "BEFORE INSTALLATION" (p.38), and then select only
appropriate the software packages to be installed.
Review the software packages to be
installed on the screen, and then click
the "Start" button.
The software packages to be installed will be
displayed on the screen. If inappropriate
packages are displayed, click the "Back" button
to select appropriate packages again.
Copying files for MFP driver installation and parallel interface
setup (This step will start if it was selected in step 4).
1 After confirming the message in the "Welcome" window, click the
"Next" button.
2 A dialog box appears asking you to verify that the USB or parallel
interface cable is not connected to the MFP. Make sure that the
interface cable is not connected and click the "Next" button.
3 Click the "Next" button in the dialog box to
install the MFP driver or Cancel to quit the
installation.
The setup program will start to copy the files.
If the following screen appears while the files are
being copied (the message may appear more
than once), click "Continue Anyway".
4 When the "The MFP driver installation is complete." dialog box
appears, click the "OK" button.
The Button Manager installer will start.
http://www.usersmanualguide.com/
7
41