Workstation; Danger Zone - Rapid Mondo 1550 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2.1

Workstation

2.2

Danger zone

EN
110
Working place [A] is situated directly on the handlebar. The operator must not leave the
handlebar while working.
Working on even terrains and slopes with an inclination of up to max. 40%.
The danger zone [B] is defined from the attachment device as follows:
10 m to the front.
10 m to each side.
to the rear up to the wheel axle of the machine.
Working on slopes with inclinations above 40% or on uneven terrain.
On slopes with an inclination of more than 40% or on uneven terrain, the machine may slip
or topple over thus increasing the original danger area by the potential slipping and toppling
area of the machine [C]. Further information chapter 2.4.
In case of attachment units with risk of projected parts, the danger area of the device
manufacturer applies.
The machine can trap the user or third persons, cause them to fall over, run them over,
crush or lacerate them. Apart from this there is a danger of flying stones.
The operator bears the full responsibility that there are no persons within the danger
zone.
Do not touch machine parts until they have come to a complete standstill (moving parts
continue to run).
Keep a safe distance when working with attachment units.
A
+ 10
m
+10 m
B
C
Note
Danger
+ 10 m
Machine no. from CI 1001

Publicidad

Tabla de contenido
loading

Tabla de contenido