Starting The Engine; Turning Off The Engine; Starting Off And Stopping - Rapid Mondo 1550 Manual De Instrucciones

5.2

Starting the engine

Prerequisites • Apply the parking brake.
• Bring the forward/reverse control into 0 position.
• Open the fuel valve.
• Actuate the choke (only for cold starts).
• Bring the accelerator lever into middle position.
Starting • Sharply pull the reversing starter evenly until the engine starts running. Then let the cord
procedure slowly wind up again
or
Turn the starter key to position "2" (max. 3 sec.). Release the key as soon as the engine
starts running, it automatically returns to position "1" (only in conjunction with an electric
starter).
• As soon as the motor starts running, slowly push the choke back to its original position
and bring the engine to the desired speed using the accelerator lever.
• Keep the dead man's lever pressed.
• Release the parking brake.
• Machine is ready for travel.
Adhere to the instructions in the enclosed operating instructions of the engine manufacturer.
5.3

Turning off the engine

• Adjust the accelerator lever to the lowest number of revolutions and let the engine run
for 1 or 2 minutes before switching off.
• Release the dead man's lever, the engine stops.
• Turn the starter key from position "1" to "0" (only in combination with an electric starter).
• Close the fuel valve.
5.4

Starting off and stopping

Driving forwards Slowly turn the forward/reverse control from 0 position to the right until the desired travel
speed is reached.
Reversing If the forward/reverse control is turned to the left from 0 position, the machine moves
backwards.
Stopping The machine is stopped by turning the forward/reverse control slowly back to 0 position.
Machine no. from CI 1001
Note
EN
119