Changing Hydraulic Oil And Filters - Rapid Mondo 1550 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

7.4

Changing hydraulic oil and filters

EN
7.5
Lube layout
128
Change the hydraulic oil
Dismount the base plate
Dismount the side cover
Dismount the drain plug (A)
Drain off oil
Dismount old oil filter (B)
Apply oil to the sealing ring on the new oil
filter
Mount a new oil filter
Mount the drain plug (A)
Mount the base plate
Dismount the oil level plug (C)
Bring the machine into a horizontal
position.
Dismount the filling and air ventilating
screw (D)
Attention: Do not disconnect ventilation
valve from the screw-in nipple (press-fit)
Pour oil into opening at the filling and air
ventilation screw until level (E) is reached
Mount the filling and air ventilating screw
(D)
Mount the oil level plug (C)
Let the engine idle for approx. 2 minutes.
Slowly drive the machine forwards and
backwards.
Turn off the engine
Dismount the oil level plug (C) and check
the oil level (E), top up if necessary.
Mount the oil level plug (C)
Mount the side cover
Oil level check
Normal oil level (E)
1) Handlebar bearing
2) Connecting piece
3) Lubricate PTO shaft
Lubricating grease
Lithium soap base NLGI 2 (multi-purpose
grease)
Machine no. from CI 1001

Publicidad

Tabla de contenido
loading

Tabla de contenido