Permobil ROHO AGILITY Active Aluminum Back Serie Manual Del Usuario página 12

Installation and Height Adjustment, continued
Installation Option B
Use this option if the wheelchair canes have push handles or other equipment that may interfere with installation.
1. Before installing the product make sure the hardware is correct
for the wheelchair and back shell. See "Hardware Selection".
2. Remove the cane clamp screw and the outer cane clamp.
Repeat for the other side.
3. Place the inner cane clamps around the wheelchair canes.
Attach but do not tighten the outer cane clamps, using the cane
clamp screws.
4. Slide the back shell up or down to the desired height.
Note: If the product does not fit properly on the wheelchair,
repeat "Hardware Selection".
5. Tighten the cane clamp screws until snug + one-quarter turn.
Note: If a torque wrench is available, tighten to no more than 40
inch-pounds (4.5 Newton-meters).
6. Use a tape measure to make sure the cane clamps are at the
same height.
7. If needed, adjust the height and re-tighten the hardware (see the
previous steps).
Warning: Have the individual safely transfer into the
wheelchair.
PSIS Warning: Make sure that the product is positioned so
that the bottom portion makes contact with the Posterior Superior
Iliac Spine (PSIS). If the product is NOT positioned to make
contact with the PSIS, pelvic support and trunk control may be
reduced.
ROHO AGILITY Active Aluminum Back Series Operation Manual
10
PSIS PSIS