Diagnostic Suite; Ad629 Setup - Interacoustics AD629 Manual De Instrucciones

3.9 Diagnostic suite

This section describes the data-transfer and hybrid mode (On-Line / PC-operated modes) supported by
AD629.

AD629 setup

The setup is similar to that described in the previous chapter for audiometric data transfer.
Important: Please be sure to selected the "AD629 (version 2)" (and not "AD629", which refers to the old
version).
PC controlled AD629: Unselect this if you want to run the AD629 as a standalone audiometer (i.e. not as
a hybrid audiometer) but still being connected to the Diagnostic Suite. When pressing Save Session on
the AD629, the session will automatically be transferred to the Diagnostic Suite. See below section "Sync
Mode".
AD629 - Instructions for Use - EN Page 35