Fagor CR-312 Manual De Instrucciones página 13

All manuals and user guides at all-guides.com
interior.qxd 30/1/04 19:53
4. Make sure that the filter holder is not
attached and position a container under
the drip spout of the appliance.
5. Press the coffee delivery switch, empty
half of the tank and, from time to time,
rotate the steam knob and allow a little of
the solution to come out. Then stop the
flow by pressing the switch again.
6. Allow the solution to sit for about 15
minutes, then start up the delivery again
until the tank is completely empty.
7. To eliminate residues of the solution and
scale, rinse the tank well, fill it with clean
PROBLEM
The espresso coffee is cold.
The espresso coffee does not
come out.
The espresso coffee drips from
the edges of the filter holder,
instead of from the holes.
The pump is making too much
noise.
The cream of the coffee is light in
colour (the coffee exits quickly
from the spout).
The cream of the coffee is dark
(the coffee exits slowly from the
spout).
The coffee has an acidic taste.
The milk does not froth when
making cappuccinos.
Página 11
water and insert it back into its seat.
Press the coffee delivery switch and let
the appliance operate until the tank is
completely empty.;
8. Press the switch again and repeat this
last operation one more time.
Repairs to the appliance that are necessi-
tated by scale problems will not be covered
by the guarantee unless the scale removal
described above has been carried out on a
regular basis.
PROBABLE CAUSES
• The "OK" pilot light is not on when
the coffee delivery sw
• The appliance has not been
preheated.
• The cups were not preheated.
• Lack of water in the tank.
• The holes in the filter holder
spouts are plugged.
• The filter holder is not inserted
correctly.
• The gasket of the espresso hot
water generator has lost its elasti-
city.
• The holes in the filter holder
spouts are plugged.
• The water tank is empty.
• The ground coffee is not pressed
enough.
• There is not enough ground cof-
fee
.• The coffee is ground too thickly.
• The ground coffee has been
pressed too tightly.
• There is too much ground coffee.
• The coffee is ground too finely.
• The rinse after scale removal was
not sufficient.
• The milk is not cold enough.
• The cappuccino nozzle is dirty.
12
SOLUTION
• Wait until the "OK" pilot light is on.
• Carry out the preheating, as
described in the "Preheating the
appliance" section.
• Preheat the cups by rinsing them
with hot water.
• Fill the water tank. correctly and
rotate it as far as it will go;
• Clean the holes in the spouts.
• Attach the filter holder correctly
and rotate it as far as it will go.
• Have the gasket of the espresso
hot water generator replaced at a
Service Centre.
• Clean the holes in the spouts.
• Fill the tank.
• Press the ground coffee more
strongly.
• Increase the quantity of coffee.
• Only use ground coffee for
espresso coffee makers.
• Press the coffee less.
• Decrease the quantity of ground
coffee used.
• Only use ground coffee for
espresso coffee machines.
• Rinse the appliance as described
in the "SCALE REMOVAL" sec-
tion.
• Always use milk at refrigerator
temperature.
• Clean the holes of the cappucci-
no nozzle thoroughly.