Stryker 240-099-109 Manual Del Usuario página 10

Making Roll Stand Adjustments
CAUTION: DO NOT MOVE ROLL STAND WHILE DISPLAY IS IN HIGHEST VERTICAL POSITION. LOWER
DISPLAY BEFORE MOVING ROLL STAND.
Height Adjustment
CAUTION: The Roll Stand Post operates by pneumatic pressure. The Post will travel upward when the Foot Pedal is
pressed. Ensure that nothing will obstruct upward travel before pressing the Foot Pedal.
1. Press and hold the Foot Pedal to release the Post for positioning.
2. Move the mounted instrument to the desired height and release the Foot
Pedal to lock the Post in position.
Locking the Casters
There are two (2) locking casters on the Roll Stand. Locking casters
are identified by labels on the top surface of two (2) legs of the Roll
Stand Base.
Press lever downward to lock a caster. Lift lever to unlock.
Swiveling the Flat Panel
Loosen the Swivel Adjustment Lever. Swivel flat panel to desired position.
Tighten Swivel Adjustment Lever to lock flat panel in position.
Tilting the Flat Panel and Adjusting Tilt Tension
Tilting the Flat Panel
Grasp flat panel and tilt to desired position.
Note: If tilt position cannot be maintained, see Increasing Tilt Tension section. If instrument is difficult to tilt, see
Decreasing Tilt Tension section.
Decreasing Tilt Tension
Using the 9/64'' Hex Wrench, decrease tension by turning both tilt tension screws the same number of turns counter
clockwise.
EN-10
Swivel Adjustment Lever
Unlock
Lock