Stryker 240-099-109 Manual Del Usuario página 11

Increasing Tilt Tension
Using the 9/64'' Hex Wrench, increase tension by turning both tilt tension screws the same number of turns clockwise.
Note: The Tilt Adjustment Lever is
a multi-position clamping lever that
operates by lifting, rotating, and
releasing the handle.
Cleaning and Maintenance
Cleaning
o
Wipe surfaces with soap and water or disinfectant.
o
Dry with non-abrasive cloth or paper towel.
o
To ensure ease of use, keep casters free of dirt, oil, and debris.
Maintenance
o
Periodically check all hardware and re-tighten fasteners as required.
o
Keep debris from wheel areas.
o
Check roll stand for loose, damaged and worn components and service as required.
Expected Service Life
The device's service life is largely determined by wear, cleaning methods, and any damage resulting from use. To extend
the time between device servicing, always follow the care and handling instructions in this user manual.
Inspect the Roll Stand prior to each use. If a condition relating to functionality or appearance (such as but not limited to
the following) is observed or suspected, discontinue use immediately and contact your Stryker representative.
•
Significant physical damage to the roll stand or casters (including but not limited to) damaged coatings, corrosion,
abnormal noises, sharp edges, or damage preventing a secure mounting interface
•
Inability to adjust the monitor tilt or to securely hold the desired tilt
•
Inability to adjust the height of roll stand or securely hold the desired height
•
Inability to freely move or apply the brake
•
Looseness in the pole attached to the base
•
Malfunctioning foot pedal
Tilt Tension Screws (2)
Tilt Adjustment Lever
EN-11