Stryker 240-099-109 Manual Del Usuario página 8

Mounting the Flat Panel on the Roll Stand
WARNING: This Roll Stand is intended for use with flat panel displays that have mounting holes provided
by the manufacturer and that have been evaluated for mounting. Do not modify the original enclosure of
any display to facilitate mounting onto the Roll Stand. Do not mount a load on the roll stand that exceeds
33 lb [14.9 kg].
1. Locate the 100 x 100mm mounting pattern on the rear of the flat panel (below left). Fasten the VESA Mounting
Adapter to corresponding mounting holes with four (4) M4 x 8mm PHMS (below right).
2 Thread two (2) M4 x 8mm PHMS into the upper two (2) holes of the 75 x 75mm mounting pattern on the Mounting
Adapter (below right). Leave 5 mm of thread exposed to allow screws to fit into slots on the VESA Mounting Plate.
3. Guide two (2) upper screws into slots in the Mounting Plate at top of Roll Stand (below left). Do not fully tighten these
screws until Step 4.
4. Thread two (2) M4 x 8mm PHMS into the lower two (2) mounting holes and tighten all four (4) mounting screws.
EN-8
Guide Screws into Slots
M4 x 8mm PHMS (2)
M4 x 8mm PHMS (2)
M4 x 8mm PHMS (4)