Battery safety
WARNING:
cause an explosion and cause injury. If the
battery has a deformation or is damaged,
speak to an approved Husqvarna service
agent.
WARNING:
instructions that follow before you use the
product.
•
Use protective glasses when you are near batteries.
•
Do not wear watches, jewelry or other metal objects
near the battery.
•
Keep the battery out of reach for children.
•
Charge the battery in a space with good airflow.
•
Keep flammable materials at a minimum clearance
of 1 m when you charge the battery.
•
Discard replaced batteries. See
34 .
•
Explosive gases can come from the battery. Do not
smoke near the battery. Keep the battery away from
open flames and sparks.
Transport safety
•
Use an approved transport vehicle for transportation
of the product.
•
A markets national or local regulations can set limit
to the transportation of the product.
•
The operator of the transport vehicle is responsible
to attach the product safely during transport. Refer to
Transportation on page 32 .
Safety instructions for maintenance
WARNING:
can cause injury or damage to property or
the adjacent area. Do not do maintenance
on the engine or the cutting deck without
these conditions:
•
The engine is off.
•
The product is parked on a level surface.
•
The parking brake is applied.
•
The ignition key is removed.
•
The cutting deck is disengaged.
Introduction
WARNING:
spring can break and cause injury. Wear
protective glasses when you attach or
remove the cutting deck.
12
A damaged battery can
Read the warning
Disposal on page
The product is heavy and
Assembly
The drive belt tension
•
The ignition cables are removed from the
plugs.
WARNING:
the engine contain carbon monoxide, an
odourless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with not sufficient air flow.
WARNING:
instructions that follow before you use the
product.
•
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page 19 .
schedule. See
•
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
•
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
•
Let the product become cool before you do
maintenance near the engine.
•
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
•
Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
•
Do not turn over the engine if the spark plug or
ignition cable is removed.
•
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
•
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. See
35 for highest permitted engine speed.
•
The product is approved only with the equipment
supplied or recommended by the manufacturer.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.
To attach the cutting deck
1. Park the product on level ground.
The exhaust fumes from
Read the warning
Read the caution
Technical data on page
844 - 009 - 25.11.2021