Inserting The Battery; Battery Charging; Operating Status Display Of The Charger; Power Level Display Of The Handpiece - 3M Unitek Ortholux Manual Del Usuario

Insert the battery:
Remove the protective cap from the battery
•
and keep with the unit packaging.
• Slowly insert the battery with the thread side
towards the metal housing into the handpiece
until it stops. Screw the battery clockwise by hand
until the seal is pressed firmly against the metal
housing. The unit will not function properly if the
battery is not screwed in completely!
• If the unit does not function properly, remove
the battery and reinsert it as described above.
Seal
Status LED
Steady green light
Flashes green
Steady red light
Flashes alternately red and green

Power Level Display of the Handpiece

Power Level LED
Handpiece outside the charger
Steady green light Battery is charged, handpiece ready for operation
Steady red light Warning for low battery capacity, remaining capacity
adequate typically for 20 3-second cycles
Flashes red Battery fully discharged, exposure cycle will be
completed or, if in extended mode, stopped
All manuals and user guides at all-guides.com

Battery Charging

•
•
•

Operating Status Display of the Charger

Handpiece/battery outside the charger
Charger ready for operation
n/a
Charge contact pins are wet
Malfunction in the charger
Power Level LED
Operating status
The unit contains a powerful lithium-ion
rechargeable battery. The battery does not have
any memory effect and can therefore be recharged
at any time by placing it in the charger (see
"Power Level Display of the Handpiece" below).
Alternatively, the battery in the unit can be
replaced by a spare battery (available separately)
which has been charged.
Place the handpiece on the charger for approximately
1.5 hours before the first use, in order to charge the
new battery completely for the first time.
- The status LED showing the operating status of
the charger flashes green during the charging
operation; see below "Operating Status Display
of the Charger."
Operating status
Handpiece/battery in the charger
Charging has been completed
Battery is being charged
Charge contact pins are wet
Problem during charging
Handpiece in the charger
Not possible, handpiece is in sleep mode
Not possible, handpiece is in sleep mode
Problem in charging, battery is defective or
cannot be charged
Status LED
showing operating
status
English 6