Temperature Setting - aquatermic XK46 Manual Del Usuario

Wired Controller XK46
②
The Auto mode can be only set at the master indoor unit.
③
Under Auto mode, if the indoor unit is running under Cooling, the icons"
and " " will light up; if the indoor unit is running under Heating, the
" and "
icons"

4.3 TEMPERATURE SETTING

Pressing "
temperature by 1° C or 1° F; holding "
temperature by 1° C or 1° F every 0.3s.
In Cooling, Fan, Heating, Floor Heating, 3D Heating or Space Heating mode,
temperature setting range is 16° C~30° C or 61° F ~86° F.
In Dry mode, the temperature setting range is 12° C or 54° F, 16° C~30° C or
61° F~86° F. In Dry mode, when temperature is 16° C or 61° F, continuously press
" " button twice to decrease temperature to 12° C or 54° F (when save function is
activated, the temperature in Dry mode can't be adjusted to 12°C or 54° F and the
setting range is "lowest temperature in Save mode" ~ 30°C or 86° F).
Note:
①
Under Auto mode or Absence function is activated, the setting temperature
can not be adjusted by pressing "
②
When the wired controller is connected with a Fresh Air Indoor Unit, fresh air
indoor unit code "FAP" will be displayed as shown below. Setting
temperature won't be displayed and can't be adjusted via "
The air outlet temperature in cooling or heating can only be set in the
parameter setting status.
" will light up.
" or " " button in On status increases or decreases set
" or " " button increases or decreases set
" or " ".
28
"
" or " " button.