Timer Setting; General Timer - aquatermic XK46 Manual Del Usuario

Wired Controller XK46
then press "ENTER/CANCLE" button to cancel Turbo function ; Press "FAN"
button to cancel turbo function and start auto speed.
Note:
In Dry mode, fan speed is low and can't be adjusted.
①
②
When the wired controller is connected with a Fresh Air Indoor Unit, fan
speed of indoor unit will be high fan speed only. Fan speed of indoor unit
can't be adjusted via "FAN" button.
③
If indoor unit's fan speed is set auto, indoor unit will change fan speed
automatically according to room temperature in order to make the room
temperature more stable and comfortable.

4.5 TIMER SETTING

The wired controller is equipped with two kinds of timer: general timer and
clock timer. General timer is factory defaulted setting. Please refer to Section 3.2.3
for the timer setting way.

4.5.1 General Timer

Unit On/Off after a desired hour can be set through general timer.
Set Timer: when timer is not set, press TIMER button to enter timer setting
and "HOUR" icon is blinking. Press "
TIMER button to save the setting and then exit setting.
Cancel Timer: when timer is set, press TIMER button to cancel it.
Timer setting range: 0.5~24h. Pressing "
decreases timer time by 0.5h; holding "
timer time by 0.5h every 0.3s.
In unit On status, timer Off setting is as shown in fig. 4.5 or 4.6.
" or " " button to adjust timer time. Press
" or "
" or " " button increases or decreases
30
" button increases or