Sentrysuite Connected" And "His Connected" Mode Settings - CareFusion Vyntus WALK Instrucciones De Uso

Instructions for Use Vyntus WALK

"SentrySuite connected" and "HIS connected" Mode Settings

Page 18/332
All manuals and user guides at all-guides.com
Please make sure that in "SentrySuite connected" mode of operation the
tablet PC is in the same SentrySuite network and has the latest Sentry Mobile
Data Service installed and that in "HIS connected" mode of operation the
tablet PC is in the same HIS-Network.
APP SETTINGS
Set "SentrySuite connected" or "HIS connected" mode of operation in the
"Mode of operation" field, respectively.
If "Extended Settings" is activated, the additional field "Test duration"
appears allowing the user to choose between the test duration of "6 Minutes"
and "20 Minutes" (see "Activate Extended Settings").
6MWT SETTINGS
Customisation of the tablet for the 6-Minute Walk Test is mostly the same as
for the "Standalone" mode.
NETWORK SETTINGS
To activate "USB Tethering" option, tap on the OFF/ON switch.
If USB Tethering is activated, the IP Adress field described below will disappear.
To change the network settings, tap on the "IP Address" field (not available if
USB Tethering option is activated).
The IP-ADDRESS window appears:
ABOUT
See settings in "Standalone" mode.
Please check that the total distance matches the stored settings before carrying out
the 6-Minute Walk Test.
Enter the IP-address (e.g.
192.168.0.1) of the server the
Vyntus WALK Sentry Mobile Data
Service (or in "HIS connected"
mode, the HL7 Gateway) is
installed on (e.g. SentrySuite
Server).
Enter "5311" in the "Port" field.
Tap on <Test connection> to
check the connection with the
specified network.
Version 05.00 • 06-06-2017