Technical Data; Limited Warranty; Items Not Covered By Warranty - GreenWorks 20232 Manual Del Operador

Problem Possible cause
The motor runs The chain is too
but the chain does tight.
not rotate.
The guide bar and
the chain are dam-
aged.
The motor is dam-
aged.
The motor runs
The chain is blunt.
and the chain ro-
tates, but the chain
does not cut.
The chain is in the
incorrect direction.
The chain is tight
or loose.
The machine does
not start.
The lock-out but-
ton and the trigger
are not pushed at
the same time.
The motor runs,
The machine is in
but the chain does
the protection
not cut correctly,
mode to protect
or the motor stops
the PCB.
after around 3 sec-
onds.
The chain is not
lubricated.
English
15
Solution
Adjust the chain
Motor
tension.
Replace the guide
No load speed
bar and the chain
if it is necessary.
Guide bar length
1. Pull the mains
Chain pitch
plug out of the
Chain gauge
socket.
Drive links
2. Remove the
guide bar cov-
Chain oil capacity
er.
Weight
3. Remove the
bar and saw
Chain
chain.
Guide bar
4. Clean the ma-
chine.
5. Re-start the
16
machine.
If the sprocket ro-
tates, it means the
motor works prop-
erly. If not, call
service center.
Sharpen or replace
the saw chain.
Turn the chain
Greenworks hereby warranties this product, to the original
loop to the other
purchaser with proof of purchase, for a period of three (3)
direction.
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
Adjust the chain
and all parts found to be defective, through normal use, free
tension.
of charge to the customer. This warranty is valid only for
1. Push the lock-
units which have been used for personal use that have not
out button and
been hired or rented for industrial/commercial use, and that
hold it.
have been maintained in accordance with the instructions in
2. Push the trig-
the owners' manual supplied with the product from new.
ger to start the
machine.

ITEMS NOT COVERED BY WARRANTY:

Release the trigger
1. Any part that has become inoperative due to misuse,
and start the ma-
chine again. Do
not force the ma-
2. The unit, if it has not been operated and/or maintained in
chine to cut.
Lubricate the
3. Normal wear, except as noted below;
chain to decrease
4. Routine maintenance items such as lubricants, blade
the friction. Do
not let the guide
5. Normal deterioration of the exterior finish due to use or
bar and the chain
operate without
sufficient lubri-
cant.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-888-909-6757.
15

TECHNICAL DATA

120 V AC, 60 Hz, 12.0
Amp
8500±10% RPM
16" (400 mm)
3/8" LP (9.5 mm)
0.05" (1.27 mm)
56
150 ml
8.8 lbs (4 kg)
91PJ056X/CL15056X
160SDEA041/
M1501656-1041TL

LIMITED WARRANTY

3
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
accordance with the owner's manual; or
sharpening;
exposure.
YEAR
ANS
AÑOS
EN