Troubleshooting; Environmental Protection - Worx WX255 Traducción De Las Instrucciones Originales

TROUBLE SHOOTING
Problem
Battery will not charge
Switch cannot be pressed
Driver stops during driving screws
Bit Cartridge will not rotate when
16
Cover slides.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
Possible cause
1. Charger not plugged into a
working outlet.
2. Surrounding air temperature is
too hot or too cold.
Forward/Reverse switch at middle
position
Driver battery is out of power
The cover is not fully open
Solution
1. Plug charger into a working outlet.
Check current by plugging in a lamp.
2. Move charger to an appropriate
place which temperature is suitable
for the charger.
Make sure switch is on Forward or
Reverse rotation according to project
need.
Make sure the driver is fully charged
before using it.
Make sure the Cover is fully open
and past the red line on the tool.