Troubleshooting - Duronic BPM120 Manual De Instrucciones

This section includes a list of error messages and frequently asked questions for
problems you may encounter with your blood pressure monitor. If the monitor is not
operating as you think it should, check here before arranging for servicing.
Problem Symptom
Display is dim
No power or will not light
Low Shows on the
batteries
display.
'E01' shows
'E02' shows
Error
message 'E03' shows
'E04' shows
'EExx' shows
Warning
'out' shows
message

Troubleshooting

Check This
Batteries are exhausted.
Batteries are inserted
incorrectly.
up.
AC adapter is inserted
incorrectly.
Batteries are low.
The cuff is not secure,
either too tight or too
The monitor has detected
motion, talking, or the
pulse is too poor while
measuring.
The measurement
process does not detect
the pulse signal.
The treatment of the
measurement failed.
A calibration error
occurred.
Out of range
measurement.
loose.
Loosen the clothing on the arm and
Relax for a moment and try again.
Retake the measurement. If the
problem persists, contact Duronic
for further assistance. Refer to the
warranty for contact information.
Relax for a moment. Refasten the
cuff and then measure again. If
the problem persists, contact your
24
Remedy
Replace with new batteries.
Insert the batteries correctly.
Insert the AC adapter tightly.
Replace with new batteries.
Refasten the cuff and then
measure again.
Relax for a moment and then
measure again.
then measure again.
doctor.