Maintenance; Cleaning/Replacing Filters; Cleaning The Air Hoses - Titan CAPSPRAY 75 0524031 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

Use the following procedures to keep your HVLP spray system
running properly.
Cleaning / replacing the Filters
IMPOrTaNT: Make sure the turbine is unplugged before
changing the filters.
1. Remove the filter covers on each side of the turbine by
turning them counterclockwise.
Filter cover
2. Remove each filter set (pre-filter and filter) from the filter
housing on each side of the turbine.
Filter
Pre-filter
Filter cover
3. Clean the filters. Either tap the filters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked loose
easily, soak the filters in soapy water or mineral spirits. Allow
the filters to dry completely before placing them back in the
turbine.
NOTE: Do not use highly flammable solvents, such as
lacquer thinner, to clean the filters.
4. Insert each filter back into its corresponding filter can.
5. Replace the filter covers on each side of the turbine by turning
them clockwise.
After several cleanings, it may become necessary to replace the
filters. Refer to the parts list near the end of this manual for the filter
replacement kit part number.
English
Filter cover
Pre-filter
Filter

Cleaning the air Hoses

1. Periodically wipe the outer surface of the air hose with a damp
cloth to keep clean.
IMPOrTaNT: DO NOT submerge into or flush the air hose with
water or any chemical.
IMPOrTaNT: DO NOT use methylethylketon (MEk), naphtha,
mineral spirits, paint thinner, xylol/xylene, or toluel/toluene to
clean the air hose. Exposure over time could cause damage to
the hose.
IMPOrTaNT: Store indoors with the cord wrapped around the
handle.
4
© Titan Tool Inc. All rights reserved.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido