Basic Engine Maintenance; Typical Wear Parts - Titan POWRLINER 4500 Instrucciones De Uso

Ocultar thumbs Ver también para POWRLINER 4500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PL4500
7.3
BASIC ENGINE MAINTENANCE (GAS ENGINE)
For
detailed
engine
specifications refer to the separate gasoline engine manual.
All service to the engine should be performed by a dealer
authorized by the engine manufacturer.
Use a premium quality motor oil. 10W30 is recommended
for general all temperature use. Other viscosities may be
required in other climates.
Use only a (NGK) BR-6HS spark plug. Gap the plug to 0.028
to 0.031 In. (0.7 to 0.8 mm) Always use a spark plug wrench.
DAILY
1. Check engine oil level, and fill as necessary.
2. Check gasoline level, and fill as necessary.
Always follow the fueling procedure outlined
earlier in this manual.
FIRST 20 HOURS
Change engine oil.
EVERY 100 HOURS
Change engine oil.
Clean the sediment cup.
Clean and re-gap the spark plug.
Clean the spark arrestor.
WEEKLY
Remove the air filter cover and clean the element. In
very dusty environments, check the filter daily. Replace
the element as needed. Replacement elements can be
purchased from your local engine manufacturer dealer.
maintenance
and
technical
ENGINE OPERATION AND SERVICE
Clean and oil air filter pad on gasoline engine every 25
hours or once weekly. Do not permit the air intake screen
around the fly wheel of the gas engine to load up with paint
or trash. Clean it regularly. The service life and efficiency
of the gas engine model depends upon keeping the
gasoline engine running properly. Change the oil in the
engine every 100 hours. Failure to observe this may result
in engine overheating. Consult the engine manufacturer's
service manual provided.
To conserve fuel, service life, and efficiency of the sprayer,
always operate the gasoline engine at the lowest RPM at
which it runs smoothly without laboring and delivers the
amount required for the particular painting operation.
Higher RPM does not produce higher working pressure.
The warranty on gasoline engines or electric motors is
limited to the original manufacturer.
7.4

TYPICAL WEAR PARTS

Despite the use of high-quality materials the highly abrasive
effect of the paints means that wear can occur at the following
parts:
INLET VALVE (spare part Order No.: 2411377)
For replacing refer to Section 8.2.
(failure becomes noticeable through performance loss and/or
poor or no suction)
OUTLET VALVE (spare part Order No.: 2413371)
For replacing refer to Section 8.3.
VALVE REPAIR KIT: (spare part Order No.: 2419852, (includes
the inlet and outlet valves
Contact Titan Technical Service (1-800-526-5362) or local
Titan Authorized Service Center to order repair kits.
SERVICING
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2407312

Tabla de contenido