TOUGHBUILT TB-H2-LL-30-L2 Instrucciones De Funcionamiento página 14

Out of the box, the very first thing you must do is verify calibration of the tool.
A laser level that is not calibrated and level itself is of no use. Thereafter, to
safeguard your investment and work, you should always verify the calibration,
as outlined below:
CAUTION! ANYTIME the tool is to be moved, MAKE SURE that the pendulum
is in its LOCKED position.
CAUTION! When moving the tool from a warm environment into a cool
environment, moisture may accumulate on the reflective glasses. Allow the tool to
stabilize to the new environment first. DO NOT turn on a wet or damp tool. To wipe
the Laser Reflector, use ONLY a lint-free cloth. DO NOT USE A PAPER TOWEL.
Before replacing the batteries, make sure that the Pendulum is in the LOCKED
position, and the power is turned off.
DANGER
LASER IN OPERATION
TRAINED
PERSONNEL ONLY
the first battery in the center, well above the removal band. Next, fold the band over
the battery and insert the remaining two batteries. While holding the end of the
band down, insert the lid-alignment pins into the compartment edge and close the
lid. Make sure the latch snaps in place, indicating that the lid is secured.
14
To open the battery cover, push the battery compartment
latch 6 and lift the cover slightly. Pull the lid away from
the compartment until the two securing pins on the lid are
clear of the case. The positive pole of all three batteries
should face the same direction, towards the topside of the
compartment (see + markings in the compartment). Insert