TOUGHBUILT TB-H2-LL-30-L2 Instrucciones De Funcionamiento página 19

6. Relocate the tool to the opposite side and place it at the adge of the
Painter's blue tape. Slide the Pendulum Switch
and allow time for the beam to stabilize.
7. Align the beam with the two pre-scribed lines on the tapes. Inspect the
beam position and the scribed line on the overhead tape. Measure the
distance between the scribed line and current beam (center of the beam)
and if the deviation is withing the tolerances, the Plumb (vertical) laser is
also within the calibration limits.
8. The tool is ready for use.
2
to the UNLOCK position
19