Before You Begin - Matrix PERFORMANCE ASCENT Manual Del Usuario

BEFORE YOU BEGIN

LOCATION OF THE UNIT
Place the equipment on a level and stable surface away from direct
sunlight. The intense UV light can cause discoloration on the plastics.
Locate the equipment in an area with cool temperatures and low humidity.
Please leave a free area behind the equipment that is at least 0.6 meters
(24 inches). This area must be clear of any obstruction and provide the
user a clear exit path from the equipment. Do not place the equipment in
any area that will block any vent or air openings. The equipment should
not be located in a garage, covered patio, near water or outdoors.
LEVELING THE EQUIPMENT
The equipment should be level for optimum use. Once you have
placed the equipment where you intend to use it, raise or lower one
or both of the adjustable levelers located on the bottom of the frame.
Use 6mm hex key through the access hole (shown below).
A carpenter's level is recommended.
NOTE: There are only two levelers on the equipment.
WARNING!
Our equipment is heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
TRAINING AREA
FREE AREA
0.6 (2 )
m ft
POWER
If the equipment is powered by a power supply, the power must
be plugged into the power jack, which is located in the front of the
equipment near the stabilizer tube. Unplug cord when not in use.
MOUNTING/DISMOUNTING THE EQUIPMENT
1. Stand behind the equipment.
2. While holding both of the rear arm rests for support, place your foot on the lowest foot
pedal and push pedal down into the lowest position before stepping onto foot pedal.
3. Wait until the equipment finds its resting place and then
place your other foot on the opposite pedal.
4. Bring the equipment to a complete stop before dismounting.
WARNING!
Never operate equipment if it has a damaged cord or plug, if it is
not working properly, if it has been damaged, or immersed in water.
Contact Customer Tech Support for examination and repair.
USING THE HEART RATE FUNCTION
The heart rate function on this product is not a medical device. While heart rate grips
can provide a relative estimation of your actual heart rate, they should not be relied
on when accurate readings are necessary. Some people, including those in a cardiac
rehab program, may benefit from using an alternate heart rate monitoring system
like a chest or wrist strap. Various factors, including movement of the user, may affect
the accuracy of your heart rate reading. The heart rate reading is intended only as an
exercise aid in determining heart rate trends in general. Please consult your physician.
Place the palm of your hands directly on the grip pulse handlebars. Both hands must grip
the bars for your heart rate to register. It takes 5 consecutive heart beats (15-20 seconds)
for your heart rate to register. When gripping the pulse handlebars, do not grip tightly.
Holding the grips tightly may elevate your blood pressure. Keep a loose, cupping hold.
You may experience an erratic readout if consistently holding the grip pulse handlebars.
Make sure to clean the pulse sensors to ensure proper contact can be maintained.
WARNING!
Heart rate monitoring systems may be inaccurate. Over exercising may result
in serious injury or death. If you feel faint, stop exercising immediately.
9