General Information; Safety Information; Use Of Hazard Information - Hach NV3300 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Specification
Certifications
Warranty
Table 1 Specifications—Measurement ranges and detection limits
Parameter
SAC 436 nm
True color 410 nm
Hazen 390 nm
Hazen 455 nm

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious
injury.
Indicates a potentially hazardous situation that may result in minor or moderate injury.
Indicates a situation which, if not avoided, may cause damage to the instrument. Information that requires special
emphasis.
2
Transmission at 740 nm must always be higher than 33%, if not, the content of turbid material in
the medium is too high and the path must be lower.
3
The detection limit specification refers to a standard reference solution with lab conditions.
4 English
Details
CE
EU: 2 years, US: 1 year
Measurement range based on the optical path
Unit
50 mm
1/m
0.1 to 30
mg/L Pt
2 to 560
mg/L Pt
0.8 to 220
mg/L Pt
4 to 1100
N O T I C E
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
100 mm
150 mm
0.05 to 15
0.03 to 10
1 to 280
0.6 to 185
0.4 to 110
0.3 to 75
2 to 550
1.5 to 360
2 3
250 mm
0.02 to 6
0.4 to 110
0.2 to 45
0.8 to 220

Publicidad

Tabla de contenido
loading

Tabla de contenido