Tabla De Contenido; Specifications; General Information - Hach SIP10 Instrucciones Para El Usuario

Table of contents
Specifications on page 3
General information on page 3
Installation on page 6
Operation on page 8

Specifications

Specifications are subject to change without notice.
Specification
Dimensions (W x D x H)
Enclosure
Weight
Protection class
Pollution degree
Installation category
Power supply
Operating temperature
Storage temperature
Humidity
Rinsing agent
Flow speed
Sample temperature
Sample salt content
Interface
Certifications
Warranty

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Details
Sipper unit: 120 x 85 x 200 mm (4.7 x 3.4 x 7.9 in.)
IP30
Sipper unit: 0.5 kg (1.1 lb)
II
2
II
Power is supplied by the turbidimeter through the USB cable, 530 mA, 5 V
10 to 40 °C (50 to 104 °F)
-10 to 60 °C (14 to 140 °F)
80% relative humidity, non-condensing
120 mL minimum to remove sample from the tubing
1 mL/sec
2 to 70 °C (35.6 to 158 °F)
65 g/L maximum
USB
CE
1 year (EU: 2 years)
N O T I C E
Maintenance on page 10
Troubleshooting on page 16
Replacement parts and accessories on page 16
English 3