Installation Overview - Hach NV3300 Manual Del Usuario

• Immediately set the instrument to OFF if the probe sends out smoke, noxious fumes or gets hot.
Contact the manufacturer.

Installation overview

Figure 3 shows an example of the probe installation with a chain holder option. Figure 4 shows an
example of the probe installation with a flow cell option. Refer to the installation documentation to
install the probe.
Put the probe into the sample. Make sure that the optical path is always fully immersed into the
sample. Install the probe transversally to the flow direction of the sample so the particle on the
windows are at a minimum and the nano-layer function gives the optimum support. Refer to Figure 5.
Note: Make sure that the probe does not touch the ground.
Figure 3 Chain holder installation
English 9